Zikula Community

• **unknown user**
  
  

  • Rank: Registered User
  • Registered: Mar 16, 2002
  • Last visit: Mar 13, 2004
  • Posts: 30

  Posted: Mar 08, 2004 - 03:18 PM

  I have a block on the left hand side of my site that has an HTML Page module in it. However, the block will only display plain text. If I use HTML code, the HTML code will display as plain text. How do I get it so the HTML code is actually executed? My intention is to put a picture in the block.

  • 
  •  
• **unknown user**
  
  

  • Rank: Registered User
  • Registered: Mar 16, 2002
  • Last visit: Mar 13, 2004
  • Posts: 30

  Posted: Mar 08, 2004 - 03:41 PM

  Ok I just figured out how to enable it, but by doing so, it would allow every user to display the same HTML tags as me. Is there any way to limit that?

  • 
  •  
• **unknown user**
  
  

  • Rank: Registered User
  • Registered: Mar 16, 2002
  • Last visit: Oct 21, 2009
  • Posts: 30

  Posted: Mar 09, 2004 - 01:30 AM

  Well you could, although I'm not suggesting that you do, hack the HTML block to not use pnVarPrepHTMLDisplay but rather pnVarPrepForDisplay... THe HTMLDisplay uses the settings in admin->Settings, the other does not... It'll display whatever you put in. Note! This includes doing changes and actually know what you are doing.. so I'm only pointing out that it's doable if you really want to.

  • 
  •  
•  
•  

Users on-line

• 0 users

This list is based on users active over the last 60 minutes.