- Moderated by:
- Support
How do I configure PN?
-
- rank:
-
Freshman
- registered:
- September 2002
- Status:
- offline
- last visit:
- 15.08.03
- Posts:
- 5
Hello all, I'm enjoying very much playing with PN and setting it up. However I can't figure out how to configure it and change the modules displayed. Is there documentation that explains in detail how the modules are configured, what each module does? I see in the modules section that there is a big list, but am not certain how to enable/disable them on the portal.
Any suggestion on where I should start reading about configuration would be appreciated.
-
- rank:
-
Freshman
- registered:
- March 2002
- Status:
- offline
- last visit:
- 26.11.02
- Posts:
- 19
Yes there is a documents section.
http://support.postnuke.com/
this is a good place to start looking at the documentation. also
http://www.drewvogel.com/ has several documents for the person just starting out with PN.
As far as installing a module each should have a install document that comes with the download that explaines how to install.
Normall you download the module.
unzip it.
copy the files to the modules/ directory.
logon to your site as admin,
go to the modules in admin.
regenerate the modules list
intilise the module
activate the module.
to get a module to display in the menu
go to admin> block
and add the module to menu block
the documents sites above are a much more in depth explenation then this is.
|
